EnglishEnglish

Maintenance and servicing of the powder packaging machine

● 2026-11-16 ● - ● Leave me a message

1. Add engine oil for lubrication:

It is necessary to add engine oil to all the gear meshing points, spherical bearing inlet holes, and all the moving and fitness prefabricated components of the powder automatic packaging machine at regular intervals. This should be done once per shift. The reducer must not operate without oil in the vacuum pump. When adding lubricating oil, be careful not to spill the liquid onto the rotating transmission belt, as this could cause deviation of direction, loss of rotation, or premature aging and damage of the transmission belt.


2. Regularly clean the powder packaging machine:

After the machine is in standby mode, it is necessary to immediately clean the metering and detection part, the heat sealing mechanism, especially for some raw materials with high sugar content such as puree and oil. It is best to clean the rotating disc and the opening door. The heat sealing mechanism is also a part that must be cleaned frequently to ensure clear adhesion patterns and high packaging product yield. For scattered raw materials, they should be immediately cleaned up neatly to facilitate the cleanliness and tidiness of the parts, thereby significantly enhancing their service life. In addition, the dust inside the electrical control cabinet should be frequently removed to prevent short circuit faults, common faults or poor contact phenomena, and other common problems with electrical equipment.


Send Inquiry

  • E-mail
  • E-mail
  • Whatsapp
  • QR
X
We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. By using this site, you agree to our use of cookies. Privacy Policy